Results 1 to 11 of 11
-
17-11-2022, 07:45 AM #1
Missing part needed to complete system
Going off of the diagram I have attached (although that is for a car and this is for a cellar)
I have an internal Evaporator with blower made by
Beer Master
Asset number 048024
And I am going to need the external condenser with fan
Any ideas on what to buy please and where?
-
17-11-2022, 03:39 PM #2
Re: Missing part needed to complete system
You need the condenser coil to match the compressor, have you identified a compressorcyet?
Brian - Newton Abbot, Devon, UK
Retired March 2015
-
17-11-2022, 05:31 PM #3
-
17-11-2022, 08:56 PM #4
Re: Missing part needed to complete system
You asked the same question last month.
-
17-11-2022, 09:06 PM #5
Re: Missing part needed to complete system
That asset number is just from the maintenance company.
You need the model number to match the outdoor - something like CMI407-69. Not sure where it is from memory - around the side where the pipes go in? Once you have that if it is still to be found check with Climate Center (Wolseley) as it's one of their brands.
Beermaster are one of the expensive ones so if the indoor is in poor condition consider a Marstair or J&E Hall unit instead.
Cheers,
Andy.Health and safety first..........unless I'm in a hurry.
-
22-11-2022, 07:14 PM #6
Re: Missing part needed to complete system
-
22-11-2022, 07:16 PM #7
Re: Missing part needed to complete system
To confirm right that everything is self contained in the inside unit the evaporator, the expansion vale and the drainer?
And all I need is the outdoor condensor and someone to install and gas it all to work?
-
22-11-2022, 07:20 PM #8
Re: Missing part needed to complete system
Question: Anyone hear any experance with plumbing out beer cellar systems for pubs/ bars?
I was in town the other day and they had the Christmas market on. There was a mobile bar set out in an old van with beer kegs laid all over the floor. No cellar cooling system to pre chill the beer to 12C before it enters the beer chiller
Will them give them a lot of beer waste in terms of fobbing/ froff?
-
23-11-2022, 08:59 PM #9
Re: Missing part needed to complete system
Cask Ale requires to be stored at 11c. In this weather, you can easily get away with just standing them outside with no cooling, so guess this is what you have seen
Beermaster is expensive stuff - you'll be paying a lot to get a matched beermaster condenser. An alternative approach would be to get a (far cheaper) Marstair CKA unit which can easily be hacked to work with what you have. It will do the job nicely in the right sized room
You need an engineer of course. I suggest you drop me a PM - I may be able to help.Last edited by Rtic; 23-11-2022 at 09:01 PM.
-
26-11-2022, 10:59 PM #10
Re: Missing part needed to complete system
-
09-03-2023, 07:35 AM #11
Re: Missing part needed to complete system
Thanks for sharing your idea