G50 fault codes

[marc5180]

I started a maintenance visit today at a site with a G50 controller.
After scrolling through the G50 i found one of the numers flashing a fault. It is a losnay (vam).
I went into option 4 which lists the faults and it said 035.0900 detect 035, i then reset it and i got the error code 035 0900 detect 008.

I've been on the mitsi website to try and find the fault but i can't find it.
I'm sure when i get to site tomorrow i will be able to find what the problem is anyway but the fault code will make it a little bit easier

[sinewave]

Fault Code 0900 = Test run lossnay unit, Dipswitch SW2,1 and SW2,3 on apparently!


Not sure if that helps or not!

[marc5180]

Yes that does help thanks.
We have taken over the maintenance of a building but the kit is pretty new so the origional installers must have left it like that.

[laf100]

Marc- I can't believe your company have taken on another Mitsu' VRF building after your last gas leak nightmare post!!

Sounds like this site will give you less sleepless nights!

[marc5180]

Most of the sites we work on have Mitsubishi VRF's that we look after.

Are you saying that because i had a nightmare trying to find the leak that was caused by the nail in the pipework, that my company should not take on any more mitsubishi contracts?
Surely not

[laf100]

No of course not, we all need any contracts we can get at the moment!

Its just when I saw your avitar the whole story came back to me!

[marc5180]

Ah ok sorry. I think that job will stick in my mind for a very long time and it will definatly help me next time i have a hard to find leak.

[sinewave]

Tell you what Marc if you want to upset your Boss/Client and haven't priced them already ask your Mitsi supplier for a quote for a set of replacement filters for the Losnay Heat Exchanger units!