Results 1 to 4 of 4
Thread: Grasso rc219
-
16-04-2009, 08:24 PM #1
Grasso rc219
Hello guys i,ve rebuilt the compressor and its almost same as grasso rc9 except for one roller bearing in the con rod small end and different pipe work pipe work externaly. what i need is how the machine is piped up and how it operates ,any info would be very grateful,thank you
-
16-04-2009, 09:03 PM #2
Re: Grasso rc219
Gaz.
I will send you some info!
The 2 is LP and the 1 is HP.
The HP cylinder has the roller bearing in the conrod (little end) if I remember correctly. And no spring to return the piston within the Suction loading / unloading assembly.
The difference is the discharge of the 2 LP cylinders discharge ports pipe into the suction port of the HP cylinder.
Sometimes these "intermediate stage" lines have liquid injection.
But I don't think from memory it's relevant on a 3 cylinder machine?
Anyways have a look at what I forward.
Steve.Last edited by Grizzly; 16-04-2009 at 09:39 PM.
-
16-04-2009, 10:03 PM #3
Re: Grasso rc219
Ghaz Hi, Check your mail
-
18-04-2009, 02:38 PM #4
Re: Grasso rc219
Thankyou grizzly and josef for your info and i can know test run the compressor, thankyou once again
Similar Threads
-
Grasso Single Screw Compressor
By Sturt in forum History of RefrigerationReplies: 7Last Post: 24-02-2010, 09:09 AM -
The new Grasso V series reciprocating compressor
By Sturt in forum New TechnologiesReplies: 3Last Post: 17-11-2009, 09:37 PM -
Grasso oil pump
By geoffg in forum CommercialReplies: 4Last Post: 08-08-2009, 07:55 AM -
Grasso spares
By Slush Puppy in forum Industrial CompressorsReplies: 4Last Post: 23-01-2009, 05:44 PM -
KAB (Grasso) drawing
By Gerben in forum Industrial CompressorsReplies: 5Last Post: 19-01-2008, 01:27 PM