Results 1 to 8 of 8
-
19-07-2012, 05:09 PM #1
Aquarium evaporator calculation...please help
Hello friends
Please to meet you .Is my first post here.I have a question for you if you can to help me.I want to make a aquarium chiller with 1/4 compressor..Aspera NE 6170Z,with 134a.What length must have tubing for evaporator with pipe 3/8 or 1/2?The evaporator is orange in the picture..
2012-07-18 13.39.48.jpg
-
26-07-2012, 05:00 AM #2
Re: Aquarium evaporator calculation...please help
You can wind 3/8" copper pipe to 15 coils with DIA 100mm
-
03-08-2012, 08:38 PM #3
Re: Aquarium evaporator calculation...please help
I make a heater exchanger..5meter copper pipe 3/8...
-
03-08-2012, 08:39 PM #4
Re: Aquarium evaporator calculation...please help
Is enough 1 meter capillary tube...ithink is 0,8mm diameter...?
-
03-08-2012, 08:42 PM #5
Re: Aquarium evaporator calculation...please help
-
03-08-2012, 09:17 PM #6
Re: Aquarium evaporator calculation...please help
nice job,might be an idea to put a flow switch or pressure differential switch accross the pump to prevent freeze up if you lose water flow
-
04-08-2012, 07:01 AM #7
Re: Aquarium evaporator calculation...please help
Digital thermostat have defrost probe.I install this inside of heater exchanger..
-
07-08-2012, 01:29 PM #8
Re: Aquarium evaporator calculation...please help