Results 1 to 7 of 7
-
24-01-2012, 04:57 PM #1
Liebert Hiross HPM + iCOM Web interface issue
Hi everybody,
I need your assistance on a problem with my Liebert Hiross HPM + iCom control.
I have set an IP Adress to the iCOM controller and i try to access it's web interface but the only result I have is a web page with the message
"The web interface is disabled"
I've not find the way to enable it so have you a piece of advice ?
Is there a configuration to make to make it work ?
In advance Thanks a lot for your replies.
-
26-03-2012, 08:48 AM #2
Re: Liebert Hiross HPM + iCOM Web interface issue
Hi,
same thing here, did you find a solution ?
Another thing, is your HiSNMP address responding to snmp queries ?
thanks
-
22-06-2012, 02:43 PM #3
Re: Liebert Hiross HPM + iCOM Web interface issue
Hi snik,
I have same situation but I can not even change the IP adress on the controller.
How did you do that? Using password 221 I can only access level 3 but as it seems I need level 4.
Can you help me?
thanks
-
23-06-2012, 03:25 PM #4
Re: Liebert Hiross HPM + iCOM Web interface issue
probably simple monitoring is disabled
check "Son" parameter, if is it no, you need icom service tool to enable
-
23-06-2012, 11:09 PM #5
Re: Liebert Hiross HPM + iCOM Web interface issue
found this if it helps
http://www.mediafire.com/view/?fxkt1poqgvprkvn
-
23-08-2012, 11:27 AM #6
Re: Liebert Hiross HPM + iCOM Web interface issue
Depends on which version of software is installed.
EV is the early iCom software, however the current version is PA.
EV, you simply use level 3 password & change the Son (Simple Moniitoring) parameter to yes.
PA is a different kettle of fish altogether. Level 3 password confirguration parameters can only be done through a Coldfire display, not the 3 digit display insode the machine. Even then, if tyhe simple monitoring parameter has not been included in the factory settings (usually isn't) you shall need the iCom Service Tool (iST) software installed on a laptop to be able tio add this feature. This shall need the attendance of an Emrson engineer with laptop to configure.
-
23-08-2012, 11:28 AM #7