Results 1 to 15 of 15
Thread: Stainless To Copper Joint
Threaded View
-
12-08-2003, 07:27 PM #1
Stainless To Copper Joint
I am having difficulty brazing stainless steel gas flex connector to copper fitting. I have successfully made the joint with a fluxed bronze brazing rod, but I am only able to get it done because I am so damn good. not really
Anyone have a better suggestion? The stainless is rather thin, and if I overheat the steel, I get a POP!, and whala! Look at that hole! good grief~!
Thanks in advanceLast edited by herefishy; 12-08-2003 at 07:31 PM.
Similar Threads
-
Cutting through Stainless Steel
By Abe in forum Air ConditioningReplies: 14Last Post: 14-06-2009, 03:57 AM -
oxidation scale in copper tube and fittings
By DeB in forum FundamentalsReplies: 8Last Post: 23-06-2006, 09:45 PM -
Will iron rich water attack copper & s/steel?
By garyb in forum Trouble ShootingReplies: 1Last Post: 14-02-2006, 03:55 PM -
reduce thickness of bended copper tubes
By rlim in forum Air ConditioningReplies: 4Last Post: 08-07-2003, 10:58 PM -
titanium and copper/brass/or stainless steel brazing?
By vinay in forum Trouble ShootingReplies: 4Last Post: 08-08-2002, 06:14 PM