Results 1 to 3 of 3
Threaded View
-
16-05-2008, 08:35 AM #1
Expansion Joints in the cold store floor
Though out of many installations, we never faced any probloems due to expaiosn joints in the cold store flooring, in one case since the RCC has shrunk a lite bit near the cold store doors, it had created lots of problems on the Bottom gaskets.
The Cold store is @ 60 x 40 x 12 M in size. There are Four doors , 2 on each side of 40 m side.
The Architech had no clue on this shrinkages & its effects. Are there any rules / logics on doing the expansions joints in the flooring?
Similar Threads
-
Cold room floor
By Andy AC in forum CommercialReplies: 8Last Post: 19-02-2009, 04:26 PM -
Heat load dye to Reach truck in cold store
By smpsmp45 in forum NH3Replies: 15Last Post: 17-06-2008, 11:07 PM -
Freezer Floor Patch and Expansion Joints
By nh3wizard in forum Technical SpeculationsReplies: 4Last Post: 04-09-2006, 08:30 PM -
expansion valve aint cold
By justinworne in forum Trouble ShootingReplies: 6Last Post: 26-07-2006, 10:52 PM -
Low Temperature Cold Store
By iceman007 in forum CommercialReplies: 12Last Post: 16-11-2005, 11:23 PM