Results 1 to 9 of 9
-
15-11-2012, 10:38 PM #1
Wall Hung Split Spitting out water?
Hi all,
Any ideas on why a wall hung split would 'spit' out water while operating? Other Mechanics have checked over and no fault found. I'm yet to check over, just getting some info prior to my visit.
Cheers
-
15-11-2012, 10:48 PM #2
Re: Wall Hung Split Spitting out water?
Undersized,high humidity,poor airflow,blocked drain,SOG.....
Take your pick
Cheers
StuTool's ? check ! Condom's ? check !
If you can't fix it , f*ck it !!!
-
16-11-2012, 04:42 AM #3
Re: Wall Hung Split Spitting out water?
blocked drain, cracked drip tray,
-
16-11-2012, 05:17 PM #4
Re: Wall Hung Split Spitting out water?
Dirty coil.
Mostly found in Oxfordshire, UK :)
-
16-11-2012, 06:46 PM #5
Re: Wall Hung Split Spitting out water?
drain backing up with water,may be ok most of the time but backs up after heavy use, dirty gauze on condensate pump,as others say dirty fins on coil causing water to get sucked off coil,strip unit and use nitrogen or compressed air to blast coil, be careful when using nitrogen.
-
16-11-2012, 08:08 PM #6
Re: Wall Hung Split Spitting out water?
Make sure the blades on the fan impellar are not clogged with dirt. Common problem with wall mounts resulting in poor air flow.
-
17-11-2012, 02:40 AM #7
Re: Wall Hung Split Spitting out water?
low on gas causing slight icing up with a slightly dirty coil and high humidity ? does this sound likely ?
-
19-11-2012, 09:50 PM #8
Re: Wall Hung Split Spitting out water?
-
20-11-2012, 07:04 AM #9
Re: Wall Hung Split Spitting out water?
Then there is the mould and scum build up behind the evaporator in tropical climates. Condensate pathways clog up and start dripping from various points.
To the optimist, the glass is half full. To the pessimist, the glass is half empty.