Results 1 to 5 of 5
Thread: Inset glassdoors for cold room
-
28-08-2012, 12:54 PM #1
Inset glassdoors for cold room
Anyone knows a brand who sells glassdoors (+/- 800 x 500 mm) in a frame which can be easily inserted in a hole which was made in a coldroom panel?
We have a request for a self service system with increased cooling system which can hold temperatures around 2°C in an ambient of 32°C
It's better to keep your mouth shut and give the impression that you're stupid than to open it and remove all doubt.
-
28-08-2012, 03:25 PM #2
Re: Inset glassdoors for cold room
Its a bit tricky, you will have to make two frames on the panel and insulation between them. on that insulation, you will have to connect your glass door, any galvanic connection between the two frames will cause condensation on the out frame, I would go for triple glass with inert gas in between.
-
28-08-2012, 08:54 PM #3
Re: Inset glassdoors for cold room
Peter, i use them for self service bottle coolers in off licence, i can give you a contact here for them, 800mm door in it's own frame, they also provide the racking.
alMostly found in the southern part of this green and pleasant land.
-
29-08-2012, 07:58 PM #4
Re: Inset glassdoors for cold room
What is the thickness of the panel? you want just one piece?
-
31-08-2012, 11:39 PM #5
Re: Inset glassdoors for cold room
I have had very good results using Anthony door frames. Not shure if they are available in your area tho.