few questions

[abbasi]

hi
I need DX coil software badly which can calculate 3/8" and 5/8" DX coils

also i have few questions first is

1. Can we use 1/4" sight glass in liquid line that is 3/4"
2. We are trying to use DANFOSS EXP VALVE but their ends are of steel and we have refrigerant piping of copper. how is brazing to be done.

Awaitin quick reply

[B]Note[/B] I have PSYCHOMETRIC ASHRAE CHART registered version 15 MB. those who have limit of in their inbox i can mail them
Regards

Engineer Ali Abbasi

[BESC5240]

Hi,
about your questions:
1. Yes you can, but don't put the sight glass in the 3/4" line, but put in a small line parallel to the major liquid line. (see attachment)
2. What kind of TEV is it? Is it a TUA (which are in stainless steel but have bi-metal connections for fast and easy soldering to cupper)?

[lana]

There is a software from USA Coils which they give with thier catalouge (Free). You can design DX coils with it but I found that it is not very reliable.
If you use 1/4" sight glass in a 3/4" liquid line then you will end up with a large pressure drop across the sight glass which will vaporize some of the liquid.

[US Iceman]

I have PSYCHOMETRIC ASHRAE CHART registered version 15 MB. those who have limit of in their inbox i can mail them

I believe this software is coyright protected by ASHRAE, I would not recommend sending copies of this. Especially since you have your name attached to the offer.

[selvaraj]

Hi,
I am fresh HVAC engineer.i have PSYCHOMETRIC chart old one (from my college book).pl. fwd the PSYCHOMETRIC ASHRAE CHART to my mail selva_sraj@hotmail.com
thanking you.
regards
selvaraj

[NoNickName]

There is an appropriate brazing material for steel to copper lap joint. Ask your supplier for details. Please note that TUBE TXVs have copper plating on the inside of steel.