Results 1 to 6 of 6
-
27-12-2010, 04:59 AM #1
Samsung blinking OPERATION light AQV24UWAX
Hey guys,
I have a SAMSUNG AQV24UWAX installed around 2 months ago, today i went out and come home and saw the "operation" light blinking, so i hit power and all came on OK and everything seems to be ok
I noticed that an hour prior to this we had a power outage also as my microwave time was reset etc
I looked up this light and apparantly it means diag mode, so i popped the cable cover off on the outdoor unit to see if anything was up and the small PCB in there that has a button and 3 LEDS (Red, Green, Yellow) showed a RED led as ON and the GREEN led was blinking (note i had the A/C on at this time)
So i reset the circuit breaker to see if that would clear anything, and the unit came on, with the operation led blinking for around 10 secs, then it went off, and all "appears" to be normal, however i have not checked the outdoor unit again
Any idea's??
-
27-12-2010, 05:14 AM #2
Re: Samsung blinking OPERATION light AQV24UWAX
Update -
Just checked the outdoor unit again, with the AC not running and the RED light is on and the Green light is flashing still?
I attached a pic.
-
27-12-2010, 02:01 PM #3
Re: Samsung blinking OPERATION light AQV24UWAX
dear Sir,
please see service manual i found, sorry not all in English but shows errors:
https://www.yousendit.com/download/R...cHZ3NUpjR0E9PQ
i can not see your error listed, maybe worth re-checking.Paul
"KEEP IT COOL"
-
27-12-2010, 10:57 PM #4
Re: Samsung blinking OPERATION light AQV24UWAX
thank you for your reply.
I am unable to open that PDF, im told its not a valid PDF file?
Also, to recheck, what am i checking???
-
29-12-2010, 11:44 AM #5
Re: Samsung blinking OPERATION light AQV24UWAX
on some of the outdoor units if you take the top of them it gives you the meaning of the fault code
-
29-12-2010, 08:43 PM #6
Re: Samsung blinking OPERATION light AQV24UWAX
Hi, call Samsung in uk or email them as your a big time difference.
I had very same on a UK version of kit. It turned out to be cause from the power failure. The indoor unit needs re address set up configeration. Theres a specific code for your machine & its simple to follow & all done from hand held remote.
Good luck
Regards Dellapureneed
Similar Threads
-
How many forum posters does it take to change a light bulb....
By taz24 in forum Chit Chat & Service StoriesReplies: 7Last Post: 04-02-2008, 07:05 AM