Results 1 to 4 of 4
Thread: denco
-
17-06-2010, 07:22 PM #1
denco
hi
i have 2 x downflows which are on a duty/standby set up, is there a way to make each unit run independantly...i have tried to disconnect the comms but the unit goes into alarm.
these units a r22 system wit a controller wit up down and enter button...
any ideas
rgrds phil
-
17-06-2010, 07:41 PM #2
Re: denco
hi there could you isolate one of them so the standy by unit comes on.
cheers lee
-
17-06-2010, 08:23 PM #3
Re: denco
Hi Phil.
"You got mail"
Check out software level 3
Auto sequence - Stand Alone.
Grizzly
-
20-06-2010, 05:06 PM #4
Similar Threads
-
Manuals for Denco
By pavilion in forum Air ConditioningReplies: 12Last Post: 10-11-2010, 11:41 AM -
Denco Manuals
By pavilion in forum Air ConditioningReplies: 6Last Post: 29-09-2010, 10:13 PM -
Can't suss strange paramaters on Denco downflow unit
By Coolie in forum Air ConditioningReplies: 20Last Post: 26-07-2010, 03:20 PM -
Denco Close Control Units
By Freecool in forum Air ConditioningReplies: 12Last Post: 05-05-2010, 12:50 PM -
Denco Humidity Control
By chimayblnd in forum Air ConditioningReplies: 2Last Post: 08-04-2010, 12:48 PM