Results 1 to 8 of 8
Thread: Elm controller guidance
-
06-02-2005, 03:35 PM #1
Elm controller guidance
Has anybody come across a manual / troubleshooting / commissioning guide for honeywell elm controllers?
I heard that there was a guide book of sorts floating around some years ago but information on the controllers seems to be fairly limited, except for the single sheet of setpoints that comes with a new controller.
a "function description" booklet similar to the one from Danfoss would be usefull.
thanks in advance for any assistance.
-
06-02-2005, 06:27 PM #2
Re: Elm controller guidance
Hi fegral
There used to be a manual for elm controllers a while back,but have not seen one for a while. These were normally requested through elm,now all that i have seen is a couple of sheets of paper with basic diagnosis and bit switch settings. What sort of problems are you having?.Are they controller or network problems?.
tony.
-
06-02-2005, 06:47 PM #3
Re: Elm controller guidance
Hi
http://www.europe.honeywell.com/
If what your after isnt there,i have some info on most controllers etc
Best regards.Mark
-
07-02-2005, 05:35 AM #4
Re: Elm controller guidance
hi just joined up from jamaica sorry cannt help you in your search
-
08-02-2005, 08:08 PM #5
Re: Elm controller guidance
Thanks very much guys, the link to Honeywell Europe is very usefull.
I am downloading user guides etc for the various tuscan controllers as well as the pack controllers.
All i need now is a trailer behind the van to carry my collection of manuals!
thanks once again and best of luck.
-
08-02-2005, 10:37 PM #6
Re: Elm controller guidance
Hi Jamcool, welcome to RE.
Hope life/trade is good in your part of our globe.Brian - Newton Abbot, Devon, UK
Retired March 2015
-
11-02-2005, 06:45 AM #7
Re: Elm controller guidance
life is good this end no cold spells no snow,the trade is ok lived in your ends of the woods for about 4 years prefer the uk equipments to the suff in jamaica but still have to be thank full
-
11-02-2005, 07:22 AM #8
Re: Elm controller guidance
hi guys.
have question, manitowoc ice machine water cooled condenser gas pressures are about 300 psi discharge between 60 and45 psi suction,ice keeps building on 2/3 rds of evap. 1/3 no ice, water distribution tube clean but lower left hand corner of evap. no ice so unit keep alarming on long harvest time
Similar Threads
-
Micro-cool controller
By bernard in forum Supermarket RefrigerationReplies: 6Last Post: 25-08-2006, 07:10 AM -
Help with new electronic refrigerator controller !
By EngiGal in forum New TechnologiesReplies: 17Last Post: 08-04-2006, 07:39 PM -
Controller wiring
By Mickvee in forum Air ConditioningReplies: 2Last Post: 30-12-2005, 02:04 AM -
Temperature controller which operates down to -100C/-150F
By DaBit in forum IndustrialReplies: 4Last Post: 27-10-2003, 10:43 AM -
Fan Controller
By Abe in forum Trouble ShootingReplies: 4Last Post: 12-01-2002, 02:21 AM