Results 1 to 7 of 7
Thread: Setting up a York chiller
-
05-04-2009, 02:13 PM #1
Setting up a York chiller
Hello everyone. This is the first time I am writing on this website. I must say, there is a lot of handful information available on the website, and the staff along with the members are doing a great job. Keep it up! :-)
Now coming on to my question, I got a new project of setting up few York chillers (model no. YCIV 1000). In order to so, I require the pin code to operate the panels. Can anyone suggest me how to obtain the code. I would really appreciate that.
Thank you :-)
-
09-06-2009, 11:29 AM #2
Re: Setting up a York chiller
Try read manual everything they say how to do best of luck
-
09-06-2009, 12:56 PM #3
Re: Setting up a York chiller
I thought most manufacturers would refuse warranty if anyone but them comissioned a chiller?
-
09-06-2009, 01:45 PM #4
-
09-06-2009, 01:54 PM #5
Re: Setting up a York chiller
Chiller is factory tested so do not change parameters before factory confirms.
-
09-06-2009, 08:07 PM #6
Re: Setting up a York chiller
YCIV is a variable speed drive air cooled screw chiller with a rather sophisticated and complex control. The comissioning should be carried out by a product trained service engineer. Nevertheless the IOM and OI provide a lot of good information about the equipment.
RTFM always thoroughly!
Vacuum sucks!
Sience rules!
-
01-09-2009, 07:00 AM #7
Re: Setting up a York chiller
Any body facing ycav chiller high motor current tripping how your all find root cause,solution waiting your analyis thanx
Similar Threads
-
York Chiller problems
By ingherrera in forum CommercialReplies: 18Last Post: 26-07-2011, 03:10 PM -
York Chiller startup when on Emergency Power
By Apollo10 in forum Trouble ShootingReplies: 3Last Post: 22-12-2008, 07:13 PM -
need help on YORK chiller
By nassersh in forum CommercialReplies: 4Last Post: 16-12-2008, 12:47 PM -
york chiller motor rotation error
By cesarnino in forum Trouble ShootingReplies: 7Last Post: 13-12-2008, 03:43 PM -
York Screw Chiller How low will it go?????
By bruceboldy in forum Industrial CompressorsReplies: 11Last Post: 10-08-2007, 10:29 PM