marley821
26-06-2007, 06:42 PM
Hello everyone,
Need a bit of advice regarding my new vac pump 'kindly' given to me by work. I suspect I have a leak on the main fitting into the pump. It is a 3 way fitting, one is 1/4 flare, one is 3/8 flare, and the other I think (after looking on e bay!!) is 1/2" acme - this is what is leaking due to an ill fitting plastic cap.
Anyone know where I can get a fitting (in or near manchester) to either blank this off or take it to 1/4 flare - tried Dean and Wood earlier but they didnt know what it was and niether do I.
Does anyone know what 1/2" acme is?????
Vac pump model is cc- 141, tried javac website no luck.
Thanks a lot, Steve
Need a bit of advice regarding my new vac pump 'kindly' given to me by work. I suspect I have a leak on the main fitting into the pump. It is a 3 way fitting, one is 1/4 flare, one is 3/8 flare, and the other I think (after looking on e bay!!) is 1/2" acme - this is what is leaking due to an ill fitting plastic cap.
Anyone know where I can get a fitting (in or near manchester) to either blank this off or take it to 1/4 flare - tried Dean and Wood earlier but they didnt know what it was and niether do I.
Does anyone know what 1/2" acme is?????
Vac pump model is cc- 141, tried javac website no luck.
Thanks a lot, Steve