isitfixedyet
26-05-2007, 02:11 AM
I need to know from anyone that can help? what should i set these three medium temp closed meat display cases for on time setting for defrost, its a regular paragon 8140 b type, for typical conventional defrost,,,
These cases are gravity fed, not forced air!
the other thing is, is theres a low pressure control to the compressor on the service factor tubing of a reciprocator, towards the top of the can type compressor, where the factory charges or checks the unit for pressure losses, etc; thats where some guy installed the compressor control , and i believe that its a problem to hook it up there it only short cycles the compressor during the off cycle, maybe its the valves leaking by, or its a solonid valve leaking, or finally its just not the right place to insatll a low pressure control to bring on the compressor!
am I right about this being a not a right place to install it?
this is a two question post!
I just have to get off my but after defrosting these and go and do the foot work , i guess!
I did find the defrost set at one time a day for 90 minutes! that didnt do the job!
These cases are gravity fed, not forced air!
the other thing is, is theres a low pressure control to the compressor on the service factor tubing of a reciprocator, towards the top of the can type compressor, where the factory charges or checks the unit for pressure losses, etc; thats where some guy installed the compressor control , and i believe that its a problem to hook it up there it only short cycles the compressor during the off cycle, maybe its the valves leaking by, or its a solonid valve leaking, or finally its just not the right place to insatll a low pressure control to bring on the compressor!
am I right about this being a not a right place to install it?
this is a two question post!
I just have to get off my but after defrosting these and go and do the foot work , i guess!
I did find the defrost set at one time a day for 90 minutes! that didnt do the job!