gjcutts
19-10-2023, 10:54 AM
Hi Brains trust. Is anyone familiar with the operation of the DECOS III Daikin refer controller.
I have a container/ reefer that i have now operational after low gas situation. Unit works fine pulls temp to the set point, but wont shut down/ stop.
It continues to vary the suction modulating valve, eev, and coil temps to keep operating at set point/ within range.
The DECOS III service manual gives some limited operating conditions when used at a set point temperature above -10'c and appears that it never stops, if my interpretation is correct, and if run below -10'c the compressor will stop when reaches set point. (not that i have had time to run it as a freezer)
Client says unit seems to never turned off and is reflecting that in their electricity consumption!
Any feedback experience would be greatly appreciated.
Regards Graham
Daikin Reefer LXE10E-A15A
I have a container/ reefer that i have now operational after low gas situation. Unit works fine pulls temp to the set point, but wont shut down/ stop.
It continues to vary the suction modulating valve, eev, and coil temps to keep operating at set point/ within range.
The DECOS III service manual gives some limited operating conditions when used at a set point temperature above -10'c and appears that it never stops, if my interpretation is correct, and if run below -10'c the compressor will stop when reaches set point. (not that i have had time to run it as a freezer)
Client says unit seems to never turned off and is reflecting that in their electricity consumption!
Any feedback experience would be greatly appreciated.
Regards Graham
Daikin Reefer LXE10E-A15A