BROBERTSON
06-01-2023, 01:12 PM
Hi
Trying to make my life easier by getting a monitoring tool. I only look after 2 sites- with around 70 city multi outdoor units and 600 indoors - but they are getting on a bit( just like me !) with lots of minor faults - so trying to make fault finding easier.
I tried to book a Mitsubishi monitoring course - but was told while I could do the course - I couldn't purchase a interface or the software as they were only give to gold partners?.
I found a dealer in the states that will sell me a Mitsubishi PAC-USCMS-MN-1 CM NM Converter & the software-which has apparently replaced the Mitsubishi - CMS-MNG-E - - Maintenance Tool Converter, but they weren't sure if it was compatible with older units - mine are all PURY P250YMF C UNITS circa 2001
Can anyone advise if it is?
Trying to make my life easier by getting a monitoring tool. I only look after 2 sites- with around 70 city multi outdoor units and 600 indoors - but they are getting on a bit( just like me !) with lots of minor faults - so trying to make fault finding easier.
I tried to book a Mitsubishi monitoring course - but was told while I could do the course - I couldn't purchase a interface or the software as they were only give to gold partners?.
I found a dealer in the states that will sell me a Mitsubishi PAC-USCMS-MN-1 CM NM Converter & the software-which has apparently replaced the Mitsubishi - CMS-MNG-E - - Maintenance Tool Converter, but they weren't sure if it was compatible with older units - mine are all PURY P250YMF C UNITS circa 2001
Can anyone advise if it is?