Karsu
01-04-2014, 10:34 AM
compressors are Mayekewa screw type with Mypro cp3
In a scenario
Compressors will work in Auto-stage
and it is required to monitor compressors in a special SCADA software, just to monitor
Among with various data related to sytem, it is intended to collect the data of compressors to a device(basically a PLC) which communicates with RS485. The connection with pc will be formed over this device.
Problem:
a collegue insists the RS485 protocols are being used by CP3 and this device are "different"!
Also I have encountered a similiar topic which mentions Mypro CP3 and PLC connection is not feasible though imho the answers were a bit not complete(thus i brought this topic).
and the information related to CP3 on internet is very very limited.
Any ideas or information? Or can you at least tell me why i can not take input from CP3 to PLC (recall: both use RS485)
or any different ideas for monitoring?
Thank you for help
In a scenario
Compressors will work in Auto-stage
and it is required to monitor compressors in a special SCADA software, just to monitor
Among with various data related to sytem, it is intended to collect the data of compressors to a device(basically a PLC) which communicates with RS485. The connection with pc will be formed over this device.
Problem:
a collegue insists the RS485 protocols are being used by CP3 and this device are "different"!
Also I have encountered a similiar topic which mentions Mypro CP3 and PLC connection is not feasible though imho the answers were a bit not complete(thus i brought this topic).
and the information related to CP3 on internet is very very limited.
Any ideas or information? Or can you at least tell me why i can not take input from CP3 to PLC (recall: both use RS485)
or any different ideas for monitoring?
Thank you for help