for
16-02-2013, 04:05 PM
Hi everyone. Having problem with this Mits.
It doesn't heat or cool. The ventilator and compressor (Inverter) are working.
I connected manometers and the needle doesn't move from 12 bars in heating and cooling.
The gas seems to bi fine.
When I leave it off for ten min, and than turn it on ( in heating), needle raises to about
25- 30 bars, and the device heats for about a minute. Then the needle falls on 12 bars and stops heating. That doesn't change any more. Inside unit is blowing through all the time on lowest speed lukewarm air
The compressor changes speed, it seems like its working on almost top speed after a while. But it doesn't opress.
How can I check the compressor?
It doesn't heat or cool. The ventilator and compressor (Inverter) are working.
I connected manometers and the needle doesn't move from 12 bars in heating and cooling.
The gas seems to bi fine.
When I leave it off for ten min, and than turn it on ( in heating), needle raises to about
25- 30 bars, and the device heats for about a minute. Then the needle falls on 12 bars and stops heating. That doesn't change any more. Inside unit is blowing through all the time on lowest speed lukewarm air
The compressor changes speed, it seems like its working on almost top speed after a while. But it doesn't opress.
How can I check the compressor?