terelan
08-01-2013, 07:14 PM
Hi All
Just hoping to pick your brains.
I have a site with PURY250 R407C unit with 9 ducted indoors each with its own PAR27MEA remote and each remote address matching corresponding indoor. When called to site for first time I found addressing issues where previous company had mixed up some SW12 & SW11. Got all that sorted and did a full reboot.
All remotes stopped HO ing and everything seemed ready to rock and roll. ( the dot was on all the remotes before I tried to switch on. )
I turned unit on but nothing happened at remote or anywhere else. This was the same for 8 out of 9 indoors but one of them did turn on and worked fine. The other 8 would work on test run.
I then took the good remote and swapped with another and sure enough that unit then started normally and the unit that had been working would not stop on its newly swapped remote. I also ran all indoors from SW3 on outdoor and all came on no problem.
I'm wondering if anyone has come across this before because I can't get my head around the idea that 8 out of 9 remotes are faulty but there is a first time for everything. Mitsubishi believe this to be the case but I just thought I'd try you guys out first.
Thx
Just hoping to pick your brains.
I have a site with PURY250 R407C unit with 9 ducted indoors each with its own PAR27MEA remote and each remote address matching corresponding indoor. When called to site for first time I found addressing issues where previous company had mixed up some SW12 & SW11. Got all that sorted and did a full reboot.
All remotes stopped HO ing and everything seemed ready to rock and roll. ( the dot was on all the remotes before I tried to switch on. )
I turned unit on but nothing happened at remote or anywhere else. This was the same for 8 out of 9 indoors but one of them did turn on and worked fine. The other 8 would work on test run.
I then took the good remote and swapped with another and sure enough that unit then started normally and the unit that had been working would not stop on its newly swapped remote. I also ran all indoors from SW3 on outdoor and all came on no problem.
I'm wondering if anyone has come across this before because I can't get my head around the idea that 8 out of 9 remotes are faulty but there is a first time for everything. Mitsubishi believe this to be the case but I just thought I'd try you guys out first.
Thx