Ref_tech
31-07-2011, 08:43 PM
hi!
I have a Trane RTAC 155 tripping on low oil flow (code 198)
The low oil flow on ckt1 was tripping just seconds after the compressor start running,
made me suspicious it could be caused by bad transducers/sensors.
After connecting with techview unbind/binding the relevant transducers/sensors for this alarm, the unit now runs fine for a couple of days then trips out on low oil flow again ( code 198).
anyone have experienced this problem or have some thoughts about the solution?
(im sorry for bad english)
Cheers! :)
I have a Trane RTAC 155 tripping on low oil flow (code 198)
The low oil flow on ckt1 was tripping just seconds after the compressor start running,
made me suspicious it could be caused by bad transducers/sensors.
After connecting with techview unbind/binding the relevant transducers/sensors for this alarm, the unit now runs fine for a couple of days then trips out on low oil flow again ( code 198).
anyone have experienced this problem or have some thoughts about the solution?
(im sorry for bad english)
Cheers! :)