super-faast
15-07-2011, 10:51 PM
Just got this snake box up and running:). Cell phone with auto answer connected to electronics that reads DTMF tones (buttons being pressed at other end) ja sends control commands to heat pump.
Just a basic setup: Power on/off. Mode heating/auto/cooling. Temperature 16-31. Everything else is static at the moment but there seems to be plenty of free code space left in electronics to develop more controls.
Cell phone keymap of control:
1: Power ON
4: Power OFF
2: Mode->Heating
5: Mode->Auto
8: Mode->Cooling
3: +1C temp
6: +22C fixed
9: -1C temp
*: Excecute command (=send to heat pump)
Example if you want device on to heating mode and temperature set to 24C -> Call to GSM control and wait for it answer to your call. Then press 1-2-6-3-3.
It you then suddenly decide to cool room down to 21C, just press 8-9-9-9-* (or 8-6-9-*).
First impression this setup was so good that I think I have to get a nicer plastic enclosure for this puppy and let it run for ever... :)
Just a basic setup: Power on/off. Mode heating/auto/cooling. Temperature 16-31. Everything else is static at the moment but there seems to be plenty of free code space left in electronics to develop more controls.
Cell phone keymap of control:
1: Power ON
4: Power OFF
2: Mode->Heating
5: Mode->Auto
8: Mode->Cooling
3: +1C temp
6: +22C fixed
9: -1C temp
*: Excecute command (=send to heat pump)
Example if you want device on to heating mode and temperature set to 24C -> Call to GSM control and wait for it answer to your call. Then press 1-2-6-3-3.
It you then suddenly decide to cool room down to 21C, just press 8-9-9-9-* (or 8-6-9-*).
First impression this setup was so good that I think I have to get a nicer plastic enclosure for this puppy and let it run for ever... :)