Eliwell EWDR 902T

[chemi-cool]

Doe's anyone have the manual of this controller?

Its an old one, I think early 90's. Its the one that to get into the menu, you need to disconnect the power and switch it on while pressing the "set".

Thanks Guys.

[install monkey]

6612
hope u can open this

[chemi-cool]

Sorry, that's another one. Not the same but thanks anyway

[install monkey]

6613
found this

[chemi-cool]

The model before that one. I think it came out before Eliwell was part of invensys.

you are getting close though...... Thanks.

[goshen]

HI
TRY THIS IT IS INDIRECT BUT MIGHT HELP
http://www.mjsav.co.uk/Pages/icestick/Octopus%20Ice%20Stick%20Manual%20EN%20IS%201%20phase%20230V.pdf
GOOD LUCK

[install monkey]

wrong folder!!!

[chemi-cool]

Its been sorted out in the best old way > replacing it with a more modern controller.

Thanks to all of you that spared a few moments.

[Peter_1]

I nearly have all old manuals of Eliwell (from the moment they started) but none is saying you have to switch off the power. The first one had a hidden button (membrane button or a small circle button on the top of the controller you had to push with a ball point) You had to push two buttons at once and release one of them prior to the other one to enter programming mode. Could you anyhow alter something Chemi in the parameter list of an old EWDR902T?

[cadwaladr]

they are not to expensive now so its easy to change ,it annoys me sometimes trying to interrogate controllers why do we not leave a copy of the instructions in a sealed clear wallet somewhere on the plant[hidden from the muppets of course.

[Tayters]

Like writing the extra charge, pipe length or location of main breaker?

Nah, that would be far too helpful for the next bloke...

Cheers,
Andy (currently rocking out to the new album by 'Irony Maiden'):D

[install monkey]

knowledge is power!!!!

[goshen]

and power = $$$$$$$$$$$$$ !!