sermen
17-02-2011, 11:50 AM
Hello.
There is compressor Mc Quay HSA220. At work extraneous metal noise was observed. After opening of viewing covers it is revealed:
Leaky contact of a molding of a rotor to a rotor body. The molding a hand freely moves on some degrees concerning a rotor.
Question, how much densely molding should fasten to a rotor and the backlash is possible in this place.
There is compressor Mc Quay HSA220. At work extraneous metal noise was observed. After opening of viewing covers it is revealed:
Leaky contact of a molding of a rotor to a rotor body. The molding a hand freely moves on some degrees concerning a rotor.
Question, how much densely molding should fasten to a rotor and the backlash is possible in this place.