View Full Version : DX coil software
abbasi
20-05-2005, 12:59 PM
HI
can anybody give me DX coil(evaporator) software :confused:
Danfoss
21-05-2005, 05:54 AM
try at http://www.guentner-online.de/, then go to service and then downloads.
is the full selection software.
frank
21-05-2005, 10:36 AM
would that be the
herstellererklaerung&rubnum
or the
freistellungsbescheinigung&rubnum :D
Danfoss
21-05-2005, 10:46 AM
I guess the english version is more friendly... :)
abbasi
21-05-2005, 11:33 AM
Thanks maite
can u tell me which fin type to usein software coz we have plain fins of aluminum i am bit confused by which fin type to use
i just select for 12 FPI + more coz of machining constraints
the method i used to calculate DX coil was for 15 FPI
rows=............. .............. Total capacity
...................... 440Xface areaX(Critical temp-Evap. Temp.)
or say
rows = capacity divided by
{440Xface areaX(Critical temp-Evap.}
for dry coil
rows= capacity divided by {K X A X METD}
Danfoss
21-05-2005, 11:59 AM
I don't understand.
The software gives you automatically the material of the coil and of the fins, the dimmensions, the number of rows, the pressure drop etc...
Peter_1
21-05-2005, 04:36 PM
or www.lemmens.com and then software section.
abbasi
23-05-2005, 04:47 AM
HI Pete
the lemmen company site asks for username and
password :confused:
Also its about AHU
Regards
Ali
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.