PDA

View Full Version : either Carel pCO2 or its soft has failed


Yuri B.
27-04-2010, 02:43 PM
Hello.
Maybe someone, by chance, have once seen such a message on the display of the controller's terminal

Internal error n.1
Atom n. 378
Offset 15772
Contact Carel

What to blame ?
Pavelas
28-04-2010, 08:53 AM
You probably tried to program it with 1Tool:)
NoNickName
28-04-2010, 09:54 AM
Incompatibility between BIOS, BOOT and SOFTWARE?
Yuri B.
28-04-2010, 05:51 PM
I cannot work with 1-tool.
Through WinLoad I have tried to renew the bios (3.84 instead of 3.36), it refused to get uploaded without an application, so I attached the copy saved of the application, pressed "upload" : in a minute the whole thing "aborted", all communication with the controller stopped, the three leds are now constantly on meaining

application with error or no pLAN table.

That application is killed is clear, but how to return the table?
The 3-wire converter was used, through the pLan interface.
A bit of nightmare.
NoNickName
28-04-2010, 05:55 PM
Probable incompatibility between boot and bios. I'm afraid it's frozen dead. Return to Carel for reset
Yuri B.
28-04-2010, 06:03 PM
No way to reestablish the communication with the controller ("defrost" it)?
Pavelas
29-04-2010, 06:47 AM
Our engineers could try and help you, but this costs...:)
goshen
29-04-2010, 05:32 PM
Our engineers could try and help you, but this costs...:)


I am sure some advice could be past on withoutcharge ,isnt that the purpose of this forum??:(
Pavelas
29-04-2010, 06:02 PM
I was saying in this way cause as I see we are from the neighbour countries with the author, so it could cost him some pizzas or like that :D