Krolroger
14-02-2009, 09:33 PM
Hello everybody,
Just finished a domestic install of a single MHI SRK35ZG-S split which is wired into an RCE1 controller via a Mitsi interface. I don't seem to have any control of the louvers and the '3DAuto' light remains on at all times on the wall mounted unit. It goes through the modes correctly and I can control the fan speed but can't get the 'Auto@ fan setting. Do the hard wired units have less functionality than the hand held remotes? (I cut jumper 2 on the interface, by the way.) Nor can I initiate the test sequence.
Is there anything (obvious or otherwise) I might have done wrong?
Thanks for any guidance.
Just finished a domestic install of a single MHI SRK35ZG-S split which is wired into an RCE1 controller via a Mitsi interface. I don't seem to have any control of the louvers and the '3DAuto' light remains on at all times on the wall mounted unit. It goes through the modes correctly and I can control the fan speed but can't get the 'Auto@ fan setting. Do the hard wired units have less functionality than the hand held remotes? (I cut jumper 2 on the interface, by the way.) Nor can I initiate the test sequence.
Is there anything (obvious or otherwise) I might have done wrong?
Thanks for any guidance.