moondawn
21-06-2008, 11:30 AM
Hi Guys,
I installed a vrv system 6 months ago. it has a g50 controller. the client asked that i put the system in to 2 groups. in one group i had addresses 1 -5 the area was pretty much open plan.
They required 3 remote controllers fitted in this open plan area. I set the g50 up for timeclock so it comes on at 6.00 and goes off at 1800 hours.
When the workers attend work the units are working but if they change the temp up or down on two of the three remotes it reverts back to the temp on the lowest address remote controller. basically there is no point in two out the three remotes being there.
anyone know why the units can not be controlled independently if they have a remote during the day?
Thanks moondawn
I installed a vrv system 6 months ago. it has a g50 controller. the client asked that i put the system in to 2 groups. in one group i had addresses 1 -5 the area was pretty much open plan.
They required 3 remote controllers fitted in this open plan area. I set the g50 up for timeclock so it comes on at 6.00 and goes off at 1800 hours.
When the workers attend work the units are working but if they change the temp up or down on two of the three remotes it reverts back to the temp on the lowest address remote controller. basically there is no point in two out the three remotes being there.
anyone know why the units can not be controlled independently if they have a remote during the day?
Thanks moondawn