View Full Version : KAB (Grasso) drawing
Gerben
17-01-2008, 09:47 AM
Hi everybody,
does anyone have a drawing of a KAB S2/27 ?
KAB is Kühl Automaten Berlin, which is now part of Grasso.
Grasso will not give any information :( .
Thnx,
Gerben
josef
17-01-2008, 11:30 PM
Hi Gerben.
Before 15 flights am much used to work with compressors KAB (Ilka), manuals lost, will heavy is obtain. Good luck to you.
Josip
17-01-2008, 11:38 PM
Hi, Gerben :)
Hi everybody,
does anyone have a drawing of a KAB S2/27 ?
KAB is Kühl Automaten Berlin, which is now part of Grasso.
Grasso will not give any information :( .
Thnx,
Gerben
I can try to get in touch with an ex Grasso guy and ask him about....not promise anything....PM to me and write down what do you need:)
Best regards, Josip :)
Gerben
18-01-2008, 10:45 AM
Hi Josip,
thank you for your quick reply!
I have dismantled a S2/27 and a S3 2500.
The rotor journals are being chromed to the original sizes and the journal bearing are renewed, so that is not the problem.
What I need is a drawing/scheme of the axial clearances, how to adjust and install. After these 2 compressors, I get another 2 of each.
Gerben
RM-Support.nl
Hi Josip,
thank you for your quick reply!
I have dismantled a S2/27 and a S3 2500.
The rotor journals are being chromed to the original sizes and the journal bearing are renewed, so that is not the problem.
What I need is a drawing/scheme of the axial clearances, how to adjust and install. After these 2 compressors, I get another 2 of each.
Gerben
RM-Support.nl
Hi Gerben:)
I know that in the case of a Grasso the factory gives the original rotor oulet end clearance so that you can either judge the wear or set up the new bearings.
I don't think that they have changed the machines since Grasso took them over, so if you have the correct Grassso manual this should do your job.
Kind Regards Andy :)
Josip
19-01-2008, 01:27 PM
Hi, Gerben :)
Hi Josip,
thank you for your quick reply!
I have dismantled a S2/27 and a S3 2500.
The rotor journals are being chromed to the original sizes and the journal bearing are renewed, so that is not the problem.
What I need is a drawing/scheme of the axial clearances, how to adjust and install. After these 2 compressors, I get another 2 of each.
Gerben
RM-Support.nl
Please send me a PM with your email address where I can send you contact info...;)
Best regards, Josip :)
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.