Activity Stream - Refrigeration-Engineer.com forums

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums Articles Articles Blog Blogs

02-12-2024, 08:53 PM

barroca replied to a thread Supra 850 cab controller not powering up in Transport

Thanks for that Shaun, am sure these wagons are haunted or possessed, one of them just started working but came up with check but still running...

6 replies | 215 view(s)

02-12-2024, 02:46 PM

seanf replied to a thread Supra 850 cab controller not powering up in Transport

https://www.elektroda.pl/rtvforum/topic286536-660.html#gallery-1 Might be right diagram, might not.

6 replies | 215 view(s)

02-12-2024, 09:55 AM

barroca replied to a thread Supra 850 cab controller not powering up in Transport

Feel I must be missing something really basic and suffering some brain short circuit. Is there any 3 phase reverse polarity protection fitted to...

6 replies | 215 view(s)

02-12-2024, 09:49 AM

barroca replied to a thread Supra 850 cab controller not powering up in Transport

Hi Sean thanks for reply, bat test under load, Run stop sw on condenser unit. With cab control sw on voltage good on output side of run stop sw on...

6 replies | 215 view(s)

30-11-2024, 06:19 PM

seanf replied to a thread Supra 850 cab controller not powering up in Transport

Is that just a voltage check, or tested under load/battery tester? Is that the switch on the cab controller itself or back at the unit? ...

6 replies | 215 view(s)

30-11-2024, 02:23 PM

barroca replied to a thread Supra 850 cab controller not powering up in Transport

Ps voltage good at run stop switch all the time

6 replies | 215 view(s)

30-11-2024, 02:19 PM

barroca started a thread Supra 850 cab controller not powering up in Transport

Have 2 26 tonners with 850's on both have run for a few mins and now cab controllers won't power up, batteries good, bat fuse good, run stop switch...

6 replies | 215 view(s)

27-11-2024, 04:00 PM

seanf replied to a thread how to connect capacitor in three phase reciprocating compressor for chiller in Electrical

..............

3 replies | 1800 view(s)

27-11-2024, 10:21 AM

ductcleani started a thread Should AC Ducts Be Cleaned After a Pest Infestation? in Air Conditioning

After dealing with a rodent infestation in my home, I’m worried about contamination in my AC ducts. How can I ensure they’re thoroughly cleaned and...

0 replies | 139 view(s)

26-11-2024, 04:14 PM

waheri3 started a thread Boiler Replacement Question – Seeking Advice! in Heat Pumps

Hi everyone, I’m looking for some guidance on replacing my old boiler. It’s been acting up lately, and I’m considering getting a new one, but I'm...

0 replies | 124 view(s)

25-11-2024, 02:28 AM

MrFreez717 replied to a thread Howden WRViXN/255110 rotor necks dimensions in Industrial Compressors

My book shows spec of 0.095 mm to 0.136 mm clearance, max of 0.180 mm. Best regards, MrFreez717

2 replies | 332 view(s)

24-11-2024, 06:53 PM

cricri replied to a thread Practicallity of fitting soft starter to older ducted 15kW Airwell, to run offgrid in Fundamentals

Hello Dairytech, Attached a picture of the soft starter fitted to my heat pump Airwell. it's a 3Kw single phase. If you are using 3phases an inverter...

1 replies | 254 view(s)

23-11-2024, 06:09 AM

RANGER1 replied to a thread Howden WRViXN/255110 rotor necks dimensions in Industrial Compressors

Zeleman, Clearances in manual between journal & bearings.

2 replies | 332 view(s)

22-11-2024, 09:45 AM

Zeleman started a thread Howden WRViXN/255110 rotor necks dimensions in Industrial Compressors

Dear colleagues, does anyone have information on the nominal dimensions and tolerances of the rotor necks of the Howden WRViXN 255110 compressor,...

2 replies | 332 view(s)

22-11-2024, 09:30 AM

dairytech started a thread Practicallity of fitting soft starter to older ducted 15kW Airwell, to run offgrid in Fundamentals

Howdy, we have recently installed a battery and solar system and are now off-grid.Everything electrical is fine except the old Airwell ducted aircon...

1 replies | 254 view(s)

18-11-2024, 06:36 PM

mbc started a thread Password in Trouble Shooting

HiI am looking for passwords of YOYO Chiler model E2414 -201(TWS 200)Thanks MBC

0 replies | 301 view(s)

07-11-2024, 07:35 PM

dangcornish started a thread Whirlpool Service Manual HELP! in Domestic

Hi, Any ideas where i can get a service manual for a G RBB 2V 20/0. SERVICE REF 8586 413 15010Cheers Dan

0 replies | 274 view(s)

05-11-2024, 06:37 PM

kamiteo started a thread Thermoking Touchlog thermograph firmware request in Transport

Hello. Could someone share the firmware version 515.029 or higher for the Thermoking touchlog thermograph? My device is on version 515.026 and the...

0 replies | 172 view(s)