Results 1 to 3 of 3
Thread: Mitsu faults
-
23-03-2003, 10:49 AM #1
Mitsu faults
I have a Mitsus currently playing up. Model PUH-2VK
All the LED's light up except number 8. I hear a sound from the control board like a relay attempting to energise, but compressor does not switch on.
Do I change the control board?? What tests can I carry out to check what is wrong with the control board, or relays?
Thanks
-
24-03-2003, 08:07 AM #2
Check that everything that you can test works as it should, if every thiing checks out then suspect the board, the board mounted relays are not replaceable, so I suppose that when they develop a fault they are scrap. One thought though, I had one unit with a seperate supply to the outside unit and the inside unit giving the same symtoms as your unit.(But I didn't realise this I always feed both units from the master isolator) I isolated both units overnight and when I powered them up in the morning they were as happy as larry.....Heres hoping
If you badger D&W tech department they will send you Mitsubishis very good service manual.Last edited by Karl Hofmann; 24-03-2003 at 08:10 AM.
Karl
-
31-03-2003, 07:30 AM #3
Grumpy Mits'
I had a customer that found this site for me. The distributor was completely helpless. This may be useful http://www.mrslim.com/index.html
Bruce H. Robinson
bhrobin@anchor-robinson.com
company page: www.anchor-robinson.com
personal page: www.anchor-robinson.com/bruce01.html
Similar Threads
-
Earth faults
By reggie in forum Technical SpeculationsReplies: 17Last Post: 28-01-2006, 06:22 PM -
Mitsu Heavy Ind. Fault Codes...
By Scooby in forum Air ConditioningReplies: 1Last Post: 08-12-2005, 08:37 PM -
Mitsu Heavy Industry
By bobjob in forum Air ConditioningReplies: 1Last Post: 14-07-2005, 11:00 PM -
Mitsu
By Abe in forum Air ConditioningReplies: 11Last Post: 05-01-2003, 02:19 PM -
Mitsu High Wall
By Abe in forum Air ConditioningReplies: 4Last Post: 07-05-2002, 05:59 PM