Results 1 to 2 of 2
Thread: LG Air to water heat pump
-
06-06-2023, 10:06 AM #1
LG Air to water heat pump
Hi All
I have 2 LG Multi V5 ARUM200 & ARUM150 three pipe outdoor units (suction pipe blanked off/ not used) feeding 4 Hydro boxes for hot water.
When i was monitoring the system the other day i noted on the LGMV software the oil light on the master system/unit compressor 1 & 2, oil lights were off more than they were on, we have had a couple of gas leaks on the system which may have lost a bit of oil. I have checked the oil return solenoid valve which i could hear clicking on & off so i assume unless it's blocked thats o.k. i also checked the oil balance solenoid valves but they didn't have any power, not sure when they get energized? so not sure when they open??
How can i add oil & how much should i add, obviously i would normally put it in the suction line but as i said this port is not used/connected so assuming if i do try to put oil in there will it get to the compressors???
Any idea on oil type??
Thanks for any assistance
-
24-10-2023, 04:25 AM #2