Results 1 to 8 of 8
Thread: Oil pressure switch
-
09-02-2018, 12:21 PM #1
Oil pressure switch
Hi I have an oil pressure switch to replace the one that's fitted is a danfoss and I have a new ranco,does anyone know the cross reference for the terminal numbers any help would be appreciated thanks
-
09-02-2018, 01:26 PM #2
- Join Date
- Sep 2009
- Location
- Iran
- Age
- 66
- Posts
- 674
- Blog Entries
- 1
- Rep Power
- 19
Re: Oil pressure switch
Hi
-
09-02-2018, 01:38 PM #3
- Join Date
- Sep 2009
- Location
- Iran
- Age
- 66
- Posts
- 674
- Blog Entries
- 1
- Rep Power
- 19
Re: Oil pressure switch
-
11-02-2018, 06:12 AM #4
- Join Date
- Sep 2009
- Location
- Iran
- Age
- 66
- Posts
- 674
- Blog Entries
- 1
- Rep Power
- 19
Re: Oil pressure switch
-
13-02-2018, 02:04 AM #5
Re: Oil pressure switch
Hi cadwaladr
Do you have 3 or 4 wires on the Danfoss control.
Danfoss OFS wiring.jpg
This is out of the Danfoss book it might help.
Regards
PaulBorn to fish, forced to work
-
13-02-2018, 06:04 AM #6
Re: Oil pressure switch
Going back to site next week but pretty sure there is five wires,what I was looking for was the comparison between terminal numbers between danfoss and ranco terminal numbers
-
13-02-2018, 11:05 AM #7
Re: Oil pressure switch
Hi Dear
Please find the below
just copy it
Danfoss to Ranco OP.png
-
14-02-2018, 01:38 AM #8
Re: Oil pressure switch
Hi cadwaladr
The fifth wire is probably to a fault light.
Regards
PaulBorn to fish, forced to work