heavy industries error code

[europa]

hi not a clue on heavy industries so any help gratefully received.SRC71ZE-S1, three indoor wall mounts showing run light always on and timer light flashing four times.PLEASE HELP ME

[install monkey]

When a compressor discharge pipe sensor wire disconnection is
detected for 15 seconds or longer (less than 7ºC) after the outdoor
unit’s speed has continued at 0 rps or higher for 9 minutes.
(The air conditioner stops.)

[install monkey]

Temperature (°C) Resistance (kΩ)
0 164
20 62
40 26

[SeanMckenzie]

hi not a clue on heavy industries so any help gratefully received.SRC71ZE-S1, three indoor wall mounts showing run light always on and timer light flashing four times.PLEASE HELP ME

is your problem solved? i am facing similar issue so please help me out if you can..

[europa]

not been back to the job yet,could be a while yet

[install monkey]

if the sensor reads correct then check the gas charge

[SeanMckenzie]

hi not a clue on heavy industries so any help gratefully received.SRC71ZE-S1, three indoor wall mounts showing run light always on and timer cheap hid headlight kits flashing four times.PLEASE HELP ME

is your problem solved? i am facing similar issue so please help me out if you can..

Ok help me when you get it solved..

[MagicMuppetMan]

This may be of help

http://www.mhiaa.com.au/PDF%20Upload...07.13_v1.3.pdf

[europa]

never went back.another company called in and no fault found ???

[moondawn]

This may be of help

http://www.mhiaa.com.au/PDF%20Upload...07.13_v1.3.pdf

Thanks for the manual mate