Results 1 to 8 of 8
Thread: too big condenser??
-
26-12-2010, 04:17 PM #1
too big condenser??
hi, i am newbi and i have one question. What happens if you
put too big water condenser unit on air to water heat pump. Heat pump with cap. tube or tev.
thanks for anwsers.
-
26-12-2010, 05:00 PM #2
- Join Date
- Sep 2007
- Location
- Split Croatia
- Age
- 57
- Posts
- 6,151
- Blog Entries
- 6
- Rep Power
- 36
Re: too big condenser??
Nothing special if you control your flow of water.
-
26-12-2010, 05:55 PM #3
Re: too big condenser??
The outlet temperature will depend of water flow.The maximum water temperature at the condenser outlet must not be higher than values reported on operating limits of heat pump producer. In the event of higher temperatures the safety devices will trip causing the unit to shut down. If you can avoid triggering the safety devices, than nothing important will happen.
Be careful about reading health books. You may die of a misprint.
-
26-12-2010, 08:17 PM #4
Re: too big condenser??
thanks for the quick response.
if i understand correctly, if i add some
more coolant R407c (biger condenser) the system will operate normally. Thanks again.
-
26-12-2010, 08:28 PM #5
- Join Date
- Sep 2007
- Location
- Split Croatia
- Age
- 57
- Posts
- 6,151
- Blog Entries
- 6
- Rep Power
- 36
Re: too big condenser??
You are not understanding this correctly.
Refrigerant should be charged by subcooling (for R407C is usually 7K-9K or even more if piping pressure drop is high) at condenser outlet WHEN unit is near set-point and condensation saturation temperature is at design temperature (usually at 40°C).
You cannot add SOME amount. It need to be as described.
-
26-12-2010, 09:58 PM #6
Re: too big condenser??
thanks.
i did mean by superheat, i just wrote this in simple maner.
-
26-12-2010, 09:59 PM #7
Re: too big condenser??
subculing
-
26-12-2010, 10:19 PM #8
- Join Date
- Sep 2007
- Location
- Split Croatia
- Age
- 57
- Posts
- 6,151
- Blog Entries
- 6
- Rep Power
- 36
Similar Threads
-
Install condenser in opposite position its built for?
By Henry. in forum FundamentalsReplies: 24Last Post: 19-08-2010, 10:50 PM -
Parallel condensers Shell and tube paralle with Evaporative Condenser
By Herschmidt in forum NH3Replies: 2Last Post: 08-06-2010, 11:12 PM -
How to measure COP (evaporative condenser)
By Juho in forum Technical DiscussionsReplies: 5Last Post: 04-06-2010, 07:08 PM -
Evaporative Condenser system COP
By Juho in forum CommercialReplies: 0Last Post: 03-06-2010, 09:23 AM -
Air Cooled Condenser Leakage Problem with R-404A
By RADHAKRISHNARAO in forum Technical DiscussionsReplies: 19Last Post: 30-07-2008, 12:21 PM