Results 1 to 4 of 4
Thread: help for Quantum 4
-
13-11-2010, 07:03 AM #1
help for Quantum 4
Hi everyone!
Now, we have a problem with the RXF-85( Frick Quantum 4), I hope receive your help:
1. In the Main menu/ Panel setup/ Capacity control: 4 capacity control options are: Disable and I try to change Enable mode but I can't.
2. In the first screen: Operating status/ Capacity control it shows:
Status Source
Discharge pressure mode 1 Remote - I/O
3. In the Control setup/ Capacity control setpoints: it only shows: active- current capacity control.
4. In the Alarm/shutdown, it shows:
High discharge pressure alarm, and High discharge pressure shutdown but I can't delete it.
And in the control setup/ compressor safeties setpoints/ discharge safeties/ high discharge pressure mode 1:
Alarm box and shutdown box: nothing( it's not show anything)
Then I try to set alarm and shutdown box but it reboot the system immediately.
Sercurity: Full acess.
I can't understand it, You can explain to me why is it? and How do I do to change it to normal mode?( In the first screen: Operating status/ Capacity control it shows: Suction pressure mode ).
Software version 4.53 February 26, 2003
Sales order: C 0 Item: 2000
BIOS version: Award module BIOS V4.51 PG 05/17/2001- GX1-CS5530-2A434BIOC-00
Keyboard version: N/A
Analog boards information: Analog board 1 Ver. 1.06 04-01-2003
Digital boards information: Digital board 1 ver. 1.02 05-01-1997
Thanks and best regards
quyenlehuu@gmail.com
-
14-11-2010, 02:53 AM #2
Re: help for Quantum 4
Chào Q.
Nếu tôi nhớ không nhầm thì Ngắt hết điện nguồn và tháo pin CMOS giống như cách reset đối với PC.
Cần mua phụ tùng thay thế thì liên hệ với tôi
-
15-11-2010, 08:09 AM #3
Re: help for Quantum 4
Thanks Mr Tuan!
But when I reset system, all parametters( PID, I/O...) will clear, and I don't know set that parametters.
How must I do?
Thanks.
-
16-11-2010, 12:48 AM #4