Results 1 to 10 of 10
-
01-04-2010, 07:31 PM #1
commisionong engineer and project enineer
HI EVERYBODY,I AM NEW TO THIS. THIS IS MY SECOND THREAD AND I STILL HAVE NOT HAD ANY ANY REPLY.
I need to know about oil behaviore in a pumping syste. Using R507 at teperatures -40f and 2f.
I need to know if the oil sinks to the bottem or floats in a oil rich layer . Can anybody help?
Costa
-
04-04-2010, 05:23 AM #2
Re: commisionong engineer and project enineer
hello anybody home?
-
06-04-2010, 04:52 PM #3
Re: commisionong engineer and project enineer
Most compressor oils will float above R-507.
-
07-04-2010, 06:15 AM #4
Re: commisionong engineer and project enineer
Costa,I would assume that oil having a specific gravity of approx 0.98 and R507 1.05, the oil would tend to float on the top of the refrigerant. The amount would depend on the miscibility of the two at that temperature.
-
07-04-2010, 06:25 AM #5
Re: commisionong engineer and project enineer
I understand that because of the specikic gravity there will be an oil rich mixture .The miscibility I understand also depends on the temperature am I right?
-
07-04-2010, 06:34 AM #6
Re: commisionong engineer and project enineer
I assume oil and R507 expand differently at different temps,which will give them different densities that would cause them to float or sink.
-
07-04-2010, 11:17 AM #7
Re: commisionong engineer and project enineer
I didn't know you could have a flooded R507 system.
The Bridge Keeper
'Answer me these questions three, n'er the other side ye see.'
What is your name?
What is your favourite colour?
What is your suction superheat?
-
15-04-2010, 08:34 PM #8
Re: commisionong engineer and project enineer
Well we are erecting a project that does just that.
-
16-06-2010, 06:58 AM #9
good
good!Very much agree with your views!
-
23-10-2010, 02:04 AM #10
Re: commisionong engineer and project enineer
Best to contact your oil supplier and get the saturation information from them. Since the SG appears to be close together, you need exact oil data.
Ken
Similar Threads
-
Heat pump project
By et0 in forum Heat PumpsReplies: 17Last Post: 01-12-2009, 10:19 AM -
Help with project on PLC's
By stonecold1 in forum Chit Chat & Service StoriesReplies: 6Last Post: 16-11-2008, 12:02 AM -
ORC project
By Agiraias in forum New TechnologiesReplies: 2Last Post: 15-10-2007, 01:25 AM -
ORC project with refrigerants
By Agiraias in forum RefrigerantsReplies: 3Last Post: 13-09-2007, 08:49 AM