Results 1 to 2 of 2
Thread: howden wrv 255 mk5 slide valve
-
12-08-2010, 01:31 AM #1
howden wrv 255 mk5 slide valve
Cannot find anywhere in the manual on how to remove the slide valve guide block spindle. I have the plug on the bottom out but not sure how to remove the spindle, does it thread out or tap with a hammer?
-
12-08-2010, 07:30 AM #2
Re: howden wrv 255 mk5 slide valve
Tap it out with a soft hammer .
It will have an alignment pin as guide block pin is eccentric for slide alignment .
Similar Threads
-
Howden slide valve problems
By CanadianIce in forum Industrial CompressorsReplies: 9Last Post: 29-06-2010, 04:38 PM -
Slide valve wear on Grasso screw after just 54000 Hrs
By Lodiev in forum Technical SpeculationsReplies: 11Last Post: 14-09-2009, 01:21 PM -
calibrating slide valve on rxf control pannel
By marley in forum IndustrialReplies: 5Last Post: 30-08-2009, 06:26 PM -
LEV does not open
By Yuri B. in forum Air ConditioningReplies: 7Last Post: 19-07-2009, 02:37 PM -
FRICK TDSH 233 Slide Valve and guide damaged
By 404cab in forum Industrial CompressorsReplies: 9Last Post: 30-07-2008, 11:24 PM