Results 1 to 49 of 49
Thread: using nitogen when brazing
Threaded View
-
22-07-2010, 10:32 PM #11
Re: using nitogen when brazing
thats a bit rich from dakin who make a crap product and blame a bit of carbon for making a rubbish compressor fall over. sorry peter.
i allways use nitro ,but care is needed not to over do it as it will make pin holes that can be a pain to rectify.
as peter says, flow over pressure.
Similar Threads
-
Brazing vs. soldering
By DaBit in forum FundamentalsReplies: 28Last Post: 19-03-2011, 11:50 AM -
Brazing in compressors?
By troymedhurst in forum Air ConditioningReplies: 20Last Post: 23-08-2010, 08:35 PM -
Flux and no flux brazing
By SkyWalker in forum FundamentalsReplies: 7Last Post: 09-05-2010, 10:43 AM -
brazing rod standards
By brian1 in forum CommercialReplies: 5Last Post: 02-05-2009, 12:00 AM -
Brazing Procedure Qualification
By Delboy in forum FundamentalsReplies: 13Last Post: 18-12-2007, 07:04 AM