Results 1 to 2 of 2
-
23-04-2010, 07:51 AM #1
Defrost timer connection Beko CDA543F
Hi everyone! I am trying to replace defrost timer on my Beko CDA543F. The old one literally burn down after defrost hose at the top section become and water was dripping into the box. I have ordered new one, tested as advised on various sites and trying to connect. Am I right to understand that wiring on the fridge are as follows: red-line, black-compressor, white-common, yellow-heater? I have tried to connect in that order but it does't seem to have any effect. For a time been I have wired together red and black to make compressor run and manually switching off fridge 2-3 times a day. What do I miss?
-
24-04-2010, 08:14 AM #2
Re: Defrost timer connection Beko CDA543F
When you fit the timer manually advance it ,it could be in the defrost position.Wiring diagram is usually printed on the side of the timer.
You should be able to trace the heater wires.
BG
Similar Threads
-
MICROPROCESSOR DIAGNOSTICS/Differnces beteween TK/CTC
By REEFER-TEK in forum TransportReplies: 12Last Post: 27-03-2011, 04:12 AM -
No Power for Defrost Timer Motor
By kln in forum DomesticReplies: 6Last Post: 21-01-2008, 08:22 AM -
Beko CDA543FW - possible timer issues?
By crestfallen in forum DomesticReplies: 0Last Post: 16-01-2008, 05:12 PM -
defrost timer wiring codes etc ..
By 2tone in forum Trouble ShootingReplies: 11Last Post: 14-12-2007, 10:07 PM -
old traulsen defrost timer
By scott777 in forum Trouble ShootingReplies: 3Last Post: 26-09-2007, 06:03 AM