Results 1 to 5 of 5
-
13-08-2009, 06:13 PM #1
NEED HELP WITH A BEKO Model CDA 543F
Hi,
I have a lot of ice build up in the fridge, I put the automatic defrost to No. 1 as the manual says but nothing is happening and that was a few days ago, any help please
-
13-08-2009, 10:21 PM #2
Re: NEED HELP WITH A BEKO Model CDA 543F
is the side by side type..american?
-
13-08-2009, 10:22 PM #3
Re: NEED HELP WITH A BEKO Model CDA 543F
is it a side by side type..if not..where or what is iceing up?
-
14-08-2009, 09:04 PM #4
Re: NEED HELP WITH A BEKO Model CDA 543F
is it a build up on one side of the cold plate or evenly across it?
have you checked the door seals?
-
21-08-2009, 06:10 PM #5
Re: NEED HELP WITH A BEKO Model CDA 543F
what a peice of junk!!.......my daughters just stopped working....after much prodding with a meter it turns out the wiring between the stat and motor is open curcuit....the black wire from stat to compressor.
ok you might think...plug at top....plug at bottom...open it up and rewire...??..NOOOOOO.........the whole thing is built as a shell...wired and then injected with expanding foam......in reality this wiring fault = a new machine...its a writeoff....not repairable.
i have opened it up with a stanley knife and intend to rewire and refoam it....just 18 months old...junk...
Similar Threads
-
BEKO AP930 Flashing Error/Fault Code E8 - advice needed
By tamba001 in forum Trouble ShootingReplies: 7Last Post: 02-11-2010, 09:28 PM -
Model to Manufacturer Identification
By Lucas in forum Air ConditioningReplies: 5Last Post: 29-04-2009, 03:25 PM -
Fan model for system optimization
By autt in forum System OptimizationReplies: 8Last Post: 31-03-2007, 05:34 AM -
Daikin Model
By Geofridgee in forum Air ConditioningReplies: 1Last Post: 12-07-2006, 09:23 AM -
UK TV Show looking for model makers / engineers
By roadshow in forum HobbiesReplies: 1Last Post: 30-12-2003, 03:16 PM