Results 1 to 4 of 4
-
06-08-2009, 03:10 PM #1
Mitsubishi PUMY/PCFY Power Outage
I have a City Multi PUMY-P125YHMA and a PCFY-P125VGM-E. When the power went out recently, the units did not restart automatically.
Has anyone had any experience with this issue? Could the power outage have damaged the units if they were running when power was lost? Is there a setting that I need to turn on so that they will automatically restart?
Thanks for any light that you can shed on this situation.
-
06-08-2009, 04:59 PM #2
Re: Mitsubishi PUMY/PCFY Power Outage
hi if u are refering to the indoor unit the answer is yes there is a resistor r-7 on the control board u need to cut in order for the unit to restart automaticly after a powe failure the outside unit should start accordingly
-
06-08-2009, 07:13 PM #3
Re: Mitsubishi PUMY/PCFY Power Outage
All City Muli indoor units can be set for auto restart after power failure.
On the indoor control circuit board or address setting board you will find a bank of dip switches marked SW1
SW1 number 9 & 10 are used for auto restart fuction options.
SW1 - 9 on
This makes the indoor unit restart only if it was turned on at the controller when the power was cut.
So if it was off when power cut then unit does not come on.
SW1 - 10 on
This forces the indoor unit to come on even if it was switched off at the controller when the power was cut.
The unit will come on with the last setting of the remote contoller for mode set temp & fan speed.
-
14-08-2009, 04:34 PM #4
Re: Mitsubishi PUMY/PCFY Power Outage
hi,i have a mitsubishi PU-P3YGAA the unit did not outo-restart after power failure.thanks
Similar Threads
-
Power Factor
By jayaeros in forum ElectricalReplies: 4Last Post: 20-07-2009, 08:27 PM -
Mitsubishi VRF Fault
By marc5180 in forum Air ConditioningReplies: 5Last Post: 14-08-2008, 10:48 PM -
SR2 50 models electric SBY diagonostics made simple
By absolute-zero in forum TransportReplies: 5Last Post: 04-01-2008, 05:11 PM -
Mitsubishi VRF Problem
By Freecool in forum Heat PumpsReplies: 1Last Post: 02-11-2007, 10:02 PM -
NEW 3-Phase IGBT Inverter Power IC
By theberes in forum New TechnologiesReplies: 14Last Post: 01-03-2004, 01:10 AM