Results 1 to 4 of 4
-
19-05-2009, 05:53 PM #1
Pipework indentification labelling
Has anyone come accross the requiremnt to label VRF 3 pipe pipework and condensate line, if so what labels should be used as per below
Pipe service identification shall be by 300mm long coloured bands,
superimposed on the primary colour and complying with the recommendations of
BS 1710.
Reply's gratfully accepted
Regards Jools
"It's better to remain silent and be thought a fool than open ones mouth and remove all doubt"
-
19-05-2009, 08:02 PM #2
Re: Pipework indentification labelling
Have a look here
http://www.identotape.co.uk/docs/ide...olourchart.pdf
-
19-05-2009, 10:25 PM #3
Re: Pipework indentification labelling
I saw a sticker pack today from hrp and it says under bs1710 you have to stick arrows pointing with the refrigeant flow, and if it is a vrv and has refrigerant flowing both ways then you have to put arrows both ways.
-
20-05-2009, 09:09 AM #4
Re: Pipework indentification labelling
MUCHAS GRASSEY ASS- Right on the money matey, thanks so much- sometimes it's right under you nose!
"It's better to remain silent and be thought a fool than open ones mouth and remove all doubt"
Similar Threads
-
Pipework Flushing
By frank in forum Air ConditioningReplies: 9Last Post: 22-08-2009, 07:15 PM -
Installing pipework for single split unit
By electro in forum Air ConditioningReplies: 51Last Post: 05-03-2009, 06:02 PM -
Pipework
By bernard in forum Supermarket RefrigerationReplies: 4Last Post: 27-10-2007, 04:44 PM -
Pipework cleaning up (Inside)
By Latte in forum Air ConditioningReplies: 6Last Post: 22-10-2005, 05:55 PM -
Porus pipework
By Latte in forum Supermarket RefrigerationReplies: 17Last Post: 05-04-2005, 11:55 PM