Results 1 to 1 of 1
-
10-08-2008, 04:08 PM #1
have any run in to the the unit that put orifices in ea. Feed line going in
How many have run in to the the unit that put orifices in ea. Feed
line going in to the evaporator and found then plugged, What do you do?
I known many techs that replace the evaporator to fix it. Some cut the pipes and
clean the orifices out ( lot of work to do that).
This is what I came up with................... What is plugging it varnish from the windings.
Varnish melts, heat up all to orifices for 10 sec. Not looking for cheery red.
Yow can do this as you recover the gas. Change the oil why where did the varnish
come from the the windings, varnish is mix in the oil so change the oil and the drier and
charge the unit away you go. Some think that you and just change the drier and
the drier will pick it up.
If you need more then heating up the pipe's to clean it cut the L.L and the S.L and flush with RX11 and nitrogen.
Similar Threads
-
MICROPROCESSOR DIAGNOSTICS/Differnces beteween TK/CTC
By REEFER-TEK in forum TransportReplies: 12Last Post: 27-03-2011, 04:12 AM -
Superheat and Subcooling
By Chunk in forum FundamentalsReplies: 42Last Post: 15-01-2011, 01:24 AM -
Thermo King OptiSet
By REEFER-TEK in forum TransportReplies: 4Last Post: 06-12-2007, 07:23 PM -
TK basic micro-p features and functions
By REEFER-TEK in forum TransportReplies: 0Last Post: 05-12-2007, 06:25 PM -
Off-line Mitsi VRF leaks!
By sinewave in forum Air ConditioningReplies: 8Last Post: 05-06-2007, 11:18 PM