Results 1 to 6 of 6
Thread: Condenser Selection
-
16-06-2008, 11:05 AM #1
Condenser Selection
I am designing the S & T R-22 Condenser based on 26 FPI but i have 19 FPI data. Can any help in this matter
-
16-06-2008, 01:21 PM #2
Re: Condenser Selection
mr.rajkumar give me urs phone no
this is ravisankar from chennai
-
16-06-2008, 03:58 PM #3
Re: Condenser Selection
Assuming the inside surfaces of the two heat exchanger tubes are the same geometry, you need to find out what the increase in the outside surface ratio is for the 26 fpi tubes. Essentially, the higher surface ratios of the 26 fpi will decrease the total surface area required for the heat rejection you intend to meet.
If all else fails, ask for help.
-
16-06-2008, 08:36 PM #4
Re: Condenser Selection
Coment Deleted. It got wacked by Iceman. Tks!
Last edited by GXMPLX; 16-06-2008 at 10:05 PM. Reason: It got wacked by Iceman!
-
16-06-2008, 08:40 PM #5
Re: Condenser Selection
GXMPLX,
It's a shell & tube condenser, not an air-cooled one.If all else fails, ask for help.
-
17-06-2008, 09:12 AM #6
Re: Condenser Selection
My contact No is +919711170980
Similar Threads
-
Superheat and Subcooling
By Chunk in forum FundamentalsReplies: 42Last Post: 15-01-2011, 01:24 AM -
Plate Heat Exchagers - Condenser
By Billy Ray in forum Technical DiscussionsReplies: 9Last Post: 11-05-2008, 06:16 PM -
method to design air cooled condenser
By abbasi in forum New TechnologiesReplies: 4Last Post: 12-02-2008, 08:34 AM -
Optimum condenser fan speed
By star882 in forum FundamentalsReplies: 4Last Post: 27-02-2006, 01:50 AM -
Condenser Fan
By Vicky in forum Supermarket RefrigerationReplies: 3Last Post: 20-04-2005, 08:38 AM