Results 1 to 13 of 13
Thread: help needed ,
Threaded View
-
30-08-2007, 06:04 PM #1
help needed ,
Hello guys ,
i have just fitted a new comp on a domestic fridge on r134a, 130g put in , what would you think is a reasonable ruuning pressure?
when i added the gas and turned compressor on , it pulled my gauge down into a vac as if i had front seated the service valve ?? its on a capillary device which coming from air con back ground i have not really worked on ,
i changed the gas dryer , could there be a blockage on the capillary when i re-inserted it ?
after re-fitting the dryer , i was getting 0.6bar low side pressure and about 12bar high side ??
any help is much appriciated
thanks alan
Similar Threads
-
Autocascade refrigeration system: design verification needed
By DaBit in forum Technical SpeculationsReplies: 3Last Post: 07-02-2010, 07:48 AM -
Carrier 40GKX028 service manual needed
By Ireland in forum Air ConditioningReplies: 6Last Post: 08-02-2007, 07:06 PM -
UK Help needed
By Air-Con Man in forum Air ConditioningReplies: 6Last Post: 23-01-2007, 08:57 AM -
How many small strands needed to equal pipe pressure drop?
By DaBit in forum FundamentalsReplies: 17Last Post: 25-08-2003, 09:56 PM -
Help Needed Mitsi MSC07RV/MUH-07RV
By Latte in forum Air ConditioningReplies: 2Last Post: 24-08-2003, 03:00 PM