Results 1 to 19 of 19
Thread: A question on Heat-Pump.
Threaded View
-
14-01-2007, 08:49 AM #1
A question on Heat-Pump.
Hi everybody,
I am designing an air-conditioning package with heat pump. Because the cooling capacity is relatively high (16kW) then I have decided to use TEV instead of cap. Tube. Therefore, I have too use two TEVs , one for cooling and for the heating cycle.
My question is this : can I install the heating cycle TEV's bulb on to the suction of the compressor (after the 4-way valve) so there will be no over-pressurization (in the valves bulb) during the cooling cycle? A schematic picture is attached.
Also, what would be the heating cycle TEV's capacity? (to select the orifice).
Thanks for any feed back.
Cheers.
Last edited by lana; 04-04-2007 at 12:31 PM.
Even Einstein Asked Questions