Hi,

I am replacing SCPM module for 30GX115, old one was defective (sparks, burned circuit board).
I received 5001-SCPM-A2 kit, but instructions said i need to program card with PD5 SCPM REPLACEMENT software which was not included in SCPM replacement kit

We have tried to look from emea but no go. Old computers have been looked through, no go.

With PD4 SCPM (scpm3040.cmd) software downloaded in to the card, machine gives me 3 errors (load solenoid, oil solenoid, compressor contactor, alm_1 = 36 communication eroor PSIO), when i mess up the SCPM address by dip switches, i have 5 errors so i think connection between PSIO and SCPM works fine, but i think i should not waste anymore time without software mentioned in manual.

Where i could get 20IH00100.ZIP (PD5 SCPM REPLACEMENT) ?
Any other option to get it work?