Results 1 to 49 of 49
Thread: using nitogen when brazing
Threaded View
-
21-07-2010, 05:19 PM #1
using nitogen when brazing
Never used nitrogen before while brazing.
Say you are replacing any part on a system and say you have two joints to make, do you just hook up nitrogen and let it feed in while brazing? And when you are making up that last joint where does the nitrogen blow the contaminates out of system. And how much pressure do you feed in? Explain in detail please, I'm a little slow LOL
Similar Threads
-
Brazing vs. soldering
By DaBit in forum FundamentalsReplies: 28Last Post: 19-03-2011, 11:50 AM -
Brazing in compressors?
By troymedhurst in forum Air ConditioningReplies: 20Last Post: 23-08-2010, 08:35 PM -
Flux and no flux brazing
By SkyWalker in forum FundamentalsReplies: 7Last Post: 09-05-2010, 10:43 AM -
brazing rod standards
By brian1 in forum CommercialReplies: 5Last Post: 02-05-2009, 12:00 AM -
Brazing Procedure Qualification
By Delboy in forum FundamentalsReplies: 13Last Post: 18-12-2007, 07:04 AM